4/44 Bosch Rexroth AG SYHNC100-SEK...3X | RE 30162-B/04.11
About this document
About this document1
Validity of the documentation1.1
This documentation applies to the SYHNC100-SEK...3X digital controller
assembly of the VT-HNC100 product family.
For the precise identification of the products see chapter 4.3 "Identification of the
product" on page 12.
This documentation is intended for assembly fitters, operators and service
technicians and plant operators.
This documentation contains important information on the safe and appropriate
assembly, transport, electrical connection, commissioning, operation, use,
maintenance, disassembly and simple troubleshooting of the product.
You should read this documentation thoroughly, and in particular the chapter f
“Safety instructions”, page 7, before working with the product.
Additional documentation1.2
Documentations marked with the book symbol must be available to you
before handling the product and must be complied with:
Table 1:
Title Document number Document type
Digital controller assembly
SYHNC100-SEK...3X
RE 30162 Technical data sheet
Available on the
Internet under
www.
boschrexroth.
com
Declaration on the environmental
compatibility for EMC, climate
and mechanical load
RE 30162-U Environmental
statement
Available on the
Internet under
www.
boschrexroth.
com
General product information on
hydraulic products
RE 07008 Available on the
Internet under www.
boschrexroth.
com
Illustration of information 1.3
Consistent safety instructions, symbols, terms and abbreviations are used so that
you can quickly and safely work with your product using this documentation. For a
better understanding, they are explained in the following sections.
To Next Page
Loading...
