Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699959
enquiries@hyquip.co.uk
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk/web/index
6/60 About this documentation
Bosch Rexroth AG, VT-VPCD, RE 30028-B/09.13
1.3 Representation of information
In order to allow you to work directly and safely with your product, standardized
safety notes, symbols, terms and abbreviations are used. For a better understanding,
these are explained in the following sections.
1.3.1
Safety notes
This documentation contains safety notes in Chapter 2.6 “Product-specific safety
instructions“ and Chapter 3 “General notes on damage to material and the product“
as well as before a sequence of activities or instructions for action, which involve the
risk of personal injury or damage to equipment. The measures described for averting
the hazard must be observed.
Safety notes are structured as follows:
SIGNAL WORD
Type and source of hazard!
Consequences in the case of non-observance
▶ Measures to avert the hazard
▶ <List>
t Warning symbol: draws attention to a hazard
t Signal word: identifies the degree of hazard
t Type and source of hazard: identifies the type or source of the hazard
t Consequences: describes the consequences in the case of non-observance
t Precautions: states, how the hazard can be avoided
Table 2: Hazard classes according to ANSI Z535.6-2006
Warning sign, signal word Meaning
DANGER
Indicates a hazardous situation which, if not avoided, will
certainly result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
Damage to property: The product or the environment can be
damaged.
To Next Page
Loading...
