Bosch SHP65CC5UC - Page 43

Troubleshooting en-us
43
Issue Cause and troubleshooting
Four vertical LED's (i.e.
the cycle duration
indicators and the
clean indicator) all light
up at the same time.
Note:If cleaning or maintenance is necessary for
inaccessible surfaces, call Customer Service and make
an appointment with an authorized service technician. If
cleaning or maintenance is required due to usage of the
appliance or other influences, this is not covered by the
warranty and a charge will be made. See the warranty
policy for further details.
Inlet hose is kinked.
▶ Install the supply hose without kinks.
Water faucet is turned off.
▶ Open the water supply valve.
Power voltage is too low.
There is no problem with the appliance.
1. Call an electrician.
2. Have the power voltage and electrical installation
checked by an electrician.
Four vertical LED's (i.e.
the cycle duration
indicators and the
clean indicator) are all
flashing.
There is a technical issue.
1. Press .
2. Pull out the power cord plug of the appliance or
switch off the breaker.
3. Wait at least 2minutes.
4. Insert the power cord plug of the appliance in a power
outlet or switch on the breaker.
5. Switch on the appliance.
6. If the problem occurs again:
‒ Press ⁠.
‒ Close the water supply valve.
‒ Pull out the power cord plug.
‒ Contact customer service → Page55 and give the
error code.
Dishware is not dry. No rinse aid used or dosage set too low.
1.
Add Rinse aid → Page24 .
2. Set the amount of rinse aid to be dispensed.
→ "Setting the amount of rinse aid", Page25
Cycle or cycle option has no drying phase, or drying
phase is too short.
▶
Select a wash cycle with drying. → Page14
Some option buttons decrease the drying result.
Water collects in recesses of dishware or silverware.