Bosch Solution 64 - Zone Management; Bypass or Un-bypass Zones; Set Chime Zones

Solution 64
|
Installer Guide
|
Programming Overview
4-2
Bosch Security Systems | 11/05 | BLCC110I
Alpha Te x t
Text descriptions are available for Area Name, Zone Name,
User Name, Schedule Name, Holiday Name, Prox Reader Name
and Output Name. Each name can have a maximum of 16
characters.
Area 2 Name
Reception Area
PRESS
◄►, OK or MENU
When programming text, each numeric key represents a
dierent group of characters.
Pressing the same numeric key repeatedly will step you
through the available characters assigned to the key. The text
key layout is the same as most phones. Refer to the table
below for detailed character information.
Key Characters Assigned To Each Numeric Key
1 . , ? ! - & ` 1
2 A B C a b c 2
3 D E F d e f 3
4 G H I g h i 4
5 J K L j k l 5
6 M N O m n o 6
7 P Q R S p q r s 7
8 T U V t u v 8
9 W X Y Z w x y z 9
0 SPACE 0

Scroll Up through entire character list

Scroll Down through entire character list

Move to left one character position

Move to right one character position
OFF Clear from cursor postiion to end of line
Table 10: Text Keypad Character Set
Once the desired character is displayed press the right arrow
key to move to the next character position.
To save programming changes, press [OK] or press [MENU] to
exit without saving.
i
Note
The following additional special characters are available by
scrolling using the up and down arrow keys.
+ - @ # $ “ & % * : ( ) / < > =
Clock Programming
Use the left and right arrow keys to move to the eld and use
the up and down keys to change. Press [OK] to save or [MENU]
to exit without saving.
i
Note
Scroll through the hours to change from am to pm.
SET DATE AND TIME
i01-Jan-2005 12:00 am
PRESS
, OK or MENU
Te l e p h o n e N u m b e r s
To program, select primary telephone number under MENU
5-1-1 then enter the digits of the telephone number and press
the [OK] key to save.
Use the up and down arrow keys to program special characters
(•, # and Pause).
PRIMARY DEST 1 P001
0297417000
PRESS
 0-9, OK or MENU
Key Characters Assigned To Each Numeric Key
0 to 9 Enter the Digits 0 to 9
 
Scroll Up through entire character list 0 - 9 • # ,
comma = 2 second pause
 
Move to left or right one character position
OFF Clear from cursor position to end of line
Table 11: Phone Number Character Set
To save programming changes, press [OK] or press [MENU] to
exit without saving.
Reporting Back to Base
The following steps are the mimimum requirements to get the
system reporting back to base. Examples assume the panel is
disarmed with no alarms and starting from the factory default
settings.
Enter Program mode.
[1234 + MENU]
Set Time and Date.
[MENU 7-1-0]
Change Default Installer PIN.
[MENU 1-5-2]
Change Default Master Code PIN.
[MENU 1-1-1]
Enter Account (client) Number, Area 1.
[MENU 2-2-0]
Enter Base Primary Telephone Number.
[MENU 5-1-1]
Enter Base Secondary Telephone Number.
[MENU 5-1-2]
Hold Down MENU For 2 Seconds To Exit.
1)
2)
3)
4)
5)
6)
7)
8)