Bosch Solution 64 - System Programming; System Commands

Bosch Security Systems | 11/05 | BLCC110I
11-1

S e c t i o n 1 1
System Programming
This section contains the dierent parameters required that are
system related features.
The commands menu will allow you to view the panel status,
system troubles, history log, factory default and entering
service mode.
Some of the key parameters in these menus are the setting of
the date/time under Clock and Schedules which control all the
automated time functions of the system.
System commands
System > Commands >
Panel Status

-

-

MENU 7-0-0
This command displays the following panel related information
on the keypad display.
Line 1 Displays:
The panel number that you are getting information from (eg.
Node 1 = Panel 1 etc). The Solution 64 is only congured to
work with one panel.
Line 2 Displays:
The panel name and rmware version number.
Line 3 Displays:
The current panel temperature, panel power supply voltage
and any system troubles which are in eect. This line scrolls all
events continiously
Press [MENU] + [7] + [0] + [0] to view the panel status.
Panel 001 P001
Solution 64 Ver RC3 1.01
Temperature 28˚C
Press OK or MENU
Press [OK] to exit when nished.
System > Commands >
System Trouble

-

-

MENU 7-0-1
This command lists any system troubles which are currently
in eect on the system. Information is diplayed in a list format
allowing you to select a paticular event and then drill down to
view more specic information.
System trouble events such as Failure To Comminicate or Telco
Line Fail are grouped under System Trouble in the list while
1)
3)
open zones are displayed individually one per line.
When the keypad is in standby mode, system troubles and
open zones will be displayed on the status line of the keypad.
From this mode you can access the list of troubles by pressing
the down arrow.
Press [MENU] + [7] + [0] + [1] and use the up and down arrows
to highlight the trouble event in the list then press [OK].
P001 System Trouble
Z001 Zone 1 Name
Z002 Zone 2 Name
Press  OK or MENU
Selecting System Trouble from the list will show the specic
panel version information to be displayed in the rst two lines
while the third line of the display will scroll all current system
trouble events.
Panel 001 P001
Solution 64 Ver 1.02
Date and Time
Press OK or MENU
Selecting a Zone from the list will show the currrent zone state.
Zone 1 name Z001
EOL=Open
Press OK or MENU
If no System Troubles are in eect the keypad will display.
There are no
System troubles
Press OK or MENU
Press [OK] or [MENU] when nished.
i
Note
When in stand-by mode keypads will display system trouble
events on the third line of the display.
1)
2)
3)
4)
5)