Bosch Solution 64 - Page 39

Solution 64
|
Installer Guide
|
Area Programming
Bosch Security Systems | 11/05 | BLCC110I
6-7
Areas > Area Testing >
Test Options

MENU 2-9-3
1 User Test Required Y
2 Reserved N
3 Reserved N
4 Reserved N
5 Reserved N
6 Walk Test Reports Y
7 Walk Test 24-Hour Zones N
8 Walk Test Fire Zones N
The above options are programmable per area.
Enter [MENU] + [2] + [9] + [3] and select the area from the list
then press [OK].
Use the up and down arrow keys to highlight the option then
press the [ON] key to enable or the [OFF] key to disable.
 User Test Required
Reserved
Reserved
Press  OK ON OFF MENU
Repeat Step 2 until all options are programmed as required,
then press [OK] to save and exit or press [MENU] to exit
without saving.
User Test Required
This option allows the keypad assigned to the corresponding area
to display a trouble condition when a user test is due. The trouble
condition can be cleared by performing a walk test.
Walk Test Reports
This option allows the corresponding area to send Walk Test reports
when a user enters/exits walk test mode and test zones.
Walk Test 24-Hour Zones
This option allows any 24-hour (non-re) zone assigned to the
corresponding area to be tested during walk test.
Walk Test Fire Zones
This option allows 24-hour re zone assigned to the corresponding
area to be tested during walk test.
» » E N D O F S E C T I O N « «
1)
2)
3)