Bosch Solution 64 - Page 52

Solution 64
|
Installer Guide
|
Input Programming
7-12
Bosch Security Systems | 11/05 | BLCC110I
Open and close the zone that needs to be tested. When the test
has been completed the keypad will display:
Zn001 Zone 1 Name
Test Successful
Press OK or MENU
Press [OK] or [MENU] to exit.
Inputs > Input Testing >
Sensor Watch Time

MENU 3-9-2
0 3 0
(*** System Wide Parameter ***)
DAYS
This menu programs the Sensor Watch Time interval. Zones
programmed for Sensor Watch are required to seal and unseal
at least once within the Sensor Watch Time period or a trouble
message will be displayed on the keypad and a Zone Trouble
report sent.
Valid entries are 1 -255 Days and 0 = Sensor Watch Disabled
Press [MENU] + [3] + [9] + [2]. The keypad will display the
current sensor watch time (Default = 30 days).
SensorWatch Time
030 Days
Press 0-9 OK or MENU
Using the numeric keys, enter the new Sensor Watch time in
days then press [OK] to save and exit or press [MENU] to exit
without saving.
i
Note
Sensor Watch monitoring is only active when the area is in the
disarmed state. 24 hour zone types cannot be monitored using
the Sensor Watch feature.
» »
E N D O F S E C T I O N
« «
3)
4)
1)
2)