Bosch Solution 64 - Page 65

Solution 64
|
Installer Guide
|
Comms Programming
Bosch Security Systems | 11/05 | BLCC110I
9-3
Enter [MENU] + [5] + [1] + [1]. The keypad will display the
current Primary Telephone Number for Destination 1.
Primary Dest 1 P001
Press  0-9 OK to SAVE
Using the numeric keys, enter all the digits of the telephone
number. You can change a single digit by scrolling the cursor
left or right. For special characters including, pause, * or #, use
the up and down arrow keys.
Press [OK] to save and exit or press [MENU] to exit without
saving.
Comms > Telephone Number >
Secondary Dest 1

MENU 5-1-2
1 Digits 32
This menu sets the secondary telephone number for
Destination 1. This will typically be the secondary base station
receiver number.
Enter [MENU] + [5] + [1] + [2]. The keypad will display the
current Secondary Telephone Number for Destination 1.
Secondary Dest 1 P001
Press  0-9 OK to SAVE
Using the numeric keys, enter all the digits of the telephone
number. You can change a single digit by scrolling the cursor
left or right. For special characters including, pause, * or #, use
the up and down arrow keys.
Press [OK] to save and exit or press [MENU] to exit without
saving.
Comms > Telephone Number >
Primary Dest 2

MENU 5-1-3
1 Digits 32
This menu sets the primary telephone number for destination
2. This location will typically be required when the panel is
congured for dual reporting.
Enter [MENU] + [5] + [1] + [3]. The keypad will display the
current Primary Telephone Number for Destination 2.
Primary Dest 2 P001
Press  0-9 OK to SAVE
Using the numeric keys, enter all the digits of the telephone
number. You can change a single digit by scrolling the cursor
left or right. For special characters including, pause, * or #, use
the up and down arrow keys.
1)
2)
3)
1)
2)
3)
1)
2)
Press [OK] to save and exit or press [MENU] to exit without
saving.
Comms > Telephone Number >
Secondary Dest 2

MENU 5-1-4
1 Digits 32
This menu sets the secondary telephone number for
Destination 2. This location will typically be required when the
panel is congured for dual reporting.
Enter [MENU] + [5] + [1] + [4]. The keypad will display the
current Secondary Telephone Number for Destination 2.
Secondary Dest 2 P001
Press  0-9 OK to SAVE
Using the numeric keys, enter all the digits of the telephone
number. You can change a single digit by scrolling the cursor
left or right. For special characters including, pause, * or #, use
the up and down arrow keys.
Press [OK] to save and exit or press [MENU] to exit without
saving.
Comms > Telephone Number >
Domestic

-

MENU 5-1-5
First
Number
1 Digits 32
Second
Number
1 Digits 32
Third
Number
1 Digits 32
Refer to Menu 5-0-0 for instructions on Domestic Phone
Number setup.
i
Note
Up to 3 Phone numbers can be entered for Domestic dialing.
Press [OK] after each telephone number is entered to save and
move to the next number.
3)
1)
2)
3)