Bosch WBN 6000-24 CR - Appendix; Commissioning Report for the Device

Appendix
Gaz 6000 W – 6720866247 (2019/07)
42
18 Appendix
18.1 Commissioning report for the device
Customer/system user:
Surname, first name Street, house number
Telephone/fax Postcode, town
System installer:
Order number:
Appliance type: (Complete a separate report for every device!)
Serial number:
Date of commissioning:
 Individual device |  Cascade, number of devices: ......
Installation location:  Cellar |  Attic |  Other:
Ventilation apertures: Number: ......, Size: approx. cm
2
Flue gas routing:  Twin pipe system |  LAS |  Duct |  Separate pipe routing
 Plastic |  Aluminium |  Stainless steel
Total length: approx. ...... m | Elbow 90°: ...... pce | Elbow 15 - 45°: ...... pce
Leak check of the flue with a countercurrent:  Yes |  No
CO
2
value in the combustion air at maximum rated output: %
O
2
value in the combustion air at maximum rated output: %
Notes regarding underpressure or overpressure operation:
Gas setting and flue gas test:
Set gas type:
Gas supply pressure: mbar Gas static supply pressure: mbar
Set maximum rated output: kW Set minimum rated output: kW
Gas flow rate at maximum
rated output:
l/min Gas flow rate at minimum
rated output:
l/min
Net calorific value H
iB
:kWh/m
3
CO
2
at maximum rated output: % CO
2
at minimum rated output: %
O
2
at maximum rated output: % O
2
at minimum rated output: %
CO at maximum rated output: ppm
mg/kWh
CO at minimum rated output: ppm
mg/kWh
Flue gas temperature at maximum
rated output:
°C Flue gas temperature at minimum
rated output:
°C
Maximum measured flow temperature: °C Minimum measured flow temperature: °C
System Hydraulic:
 Low loss header, type:  Additional expansion vessel
 Heating pump: Size/pre-charge pressure:
Automatic air vent valve present?  Yes |  No
 DHW cylinder/type/number/heating surface output:
 System hydraulics checked, Notes: