19
Initializing only one of multiple drives
(partitions)
Now you can specify a single partition for initialization when
using multiple drives (partitions).
* Use of this feature is not required if you are using the default
factory settings without any changes, or if you are using the
hard disk initialized with Format Mode set to NORMAL or
SURFACE SCAN.
1. First, select the drive you want to initialize.
Step 4 in the “Viewing information about the hard disk
(Hard Disk Information)” p. 136 in the Owner’s Manual
2. Press [UTILITY], then press [CURSOR] to move the
cursor to “HDD,” then press [ENTER].
3. Use [CURSOR] to move the cursor to “INITIALIZE,”
then press [ENTER].
This brings up the Hard Disk Initialize screen.
4. Rotate the TIME/VALUE dial to set “Format Mode” to
“ONLY CUR. PARTITION.”
* Take care to note that selecting anything other than “ONLY
CUR. PARTITION” will result in the entire hard disk being
initialized.
5. Use [CURSOR] to move the cursor to “GO,” then press
[ENTER].
When “Sure?” appears in the display, press [YES/
ENTER] once more.
“Now Initializing...” appears, and initialization of the
drive begins. The process is finished when “Complete!”
appears.
To Next Page
Loading...
