Boss ES-5 - Phaser Control While Switch is Held; MIDI Device Memory Switching with Patches

Advanced Applications
18
Applying Phaser Only While the Currently Selected Number Switch Is Held Down
Parameter Value Reference
Patch parameter (CTL/EXP)
Assign 1
Sw ON
p. 10
Src CNum
Mod MOM
Cate, Target LOOP, L4
Min, Max OFF, ON
Act L, Act H 0, 127
Input
Buer
OUTPUT
Guitar
AMP
DELAY PHASER DIST OD COMP
INPUT
Mixer
Phaser On Phaser O
Guitar
COMP
OD PHASER DELAYDIST
AMP
Switching a MIDI-Equipped Eect Unit’s Memory When a Patch Is Changed
Parameter Value Reference
Patch Parameter
Patch MIDI 1
Ch 1–16
p. 10
LSB OFF, 0–127
MSB OFF, 0–127
PC 1–128
MIDI IN
Input
Buer
OUTPUT
Guitar
AMP
PHASER DIST OD COMP
INPUT
BOSS
DD-500
Mixer
Guitar
COMP OD PHASERDIST
AMP
DD-500
MIDI cable
MIDI-equipped eect unit
(e.g., BOSS DD-500)
* Set Ch (MIDI channel) to match the MIDI device that’s connected.
* If you want to switch more than 128 memories, use LSB and MSB
(bank select LSB, MSB) as well.
* The MIDI specication counts the PC (program change) starting
at 1, but some devices start at 0. In this case, the memory number
that is one less than the ES-5’s PC setting is selected.