Bottlehead Crack - Page 29

29
()Cutapieceofblackwire2”(50mm)
longandstripbothends1/4”(6mm).
Attach one end to terminal 14U Attach
the other end to terminal 12U.
( ) Cut a piece of black wire 6-
1/2”(167mm)longandstrip
bothends1/4”(6mm).Attach
one end to terminal 12L and
solder. Attach the other end to
the inboard terminal of the
headphone jack that is closest
to the chassis plate, and
solder.
()Cuta4”(100mm)pieceofredwire.
Striponeendback1/4”(6mm)and
striptheotherendback1”(25mm)
Attachthe1/4”strippedendtoterminal
13U.Threadthe1”strippedend
through terminal B5, then through
terminal B2. Solder 13L, solder B5.