Bpt TH 400 - Page 24

24
GB
from 1 to 99, figure 70. The hours
are counted including the hour
during which the programming
option is used (so the remainder of
the hour when the setting is made
counts as a whole hour).
Note. To return to AUTOMATIC
mode before the expiry of the pro-
grammed interval, press the
button or the button.
Programming in days
13.7 - Press the button twice,
figure 71.
The display shows the wording
d01 instead of the actual time.
T3
T2
T1
ON
048121620
0
23
1
7
C
12
3
4
56
7
Fig. 71
T3
T2
T1
ON
048121620
0
23
1
7
C
12
3
4
56
7
Fig. 69
T3
T2
T1
ON
048121620
0
23
1
7
C
12
3
4
56
7
Fig. 70
ding disappears and the display
reads: .
13.3 - Press the button or the
button to restore AUTOMATIC
thermostat control of the plant.
TIMER-CONTROLLED PLANT
STAND-BY INTERVALS
To put the plant on stand-by for
several hours or days, proceed as
follows.
In the HEATING program
13.4 - Press the button twice,
figure 68.
The bar under the symbol is
enabled to confirm the fact that the
THERMOPROGRAM is not control-
ling the plant and the program
graph disappears. For 5 s the room
temperature reading disappears
and the display reads: .
Programming in hours
13.5 - Press the button once,
figure 69.
The display shows the wording
h01 instead of the actual time.
13.6 - Press the button or
until you reach the number of
hours required, which can range
TH/400.01 ITF 2407-9122 04.06 3-05-2006 15:56 Pagina 24