BPW ECO Plus - Page 18

31
3 Lubrication
initially every 12 weeks every 26 weeks
2)
annually every 2 years after 5 years, there after every 3 years annually and at every brake lining replacement
2)
1312
1)
after a long idle period, prior to initial operation actuate the brake lever and lubricate the brake camshaft bearing.
2)
under extreme conditions, lubricate with more frequency (e.g. off-road, impeded braking effort).
3)
for use outside Europe
LLuubbrriiccaattiioonn
Overview
For detailed description see pages 33 to 36
Lubrication
LLuubbrriiccaattiioonn wwiitthh BBPPWW ssppeecciiaall lloonngglliiffee ggrreeaassee EECCOO--LLii
PPlluuss
::
1 Brake camshaft bearing, outer and inner
Low maintenance camshaft bearing from year of
manufacture 1993 short distance haulage 1
long distance haulage 1
Conventional brake camshaft bearing up to year of 11
manufacture 1992
2 Slack adjusters manual 2
Automatic slack adjuster ECOMaster (from 5/1991)
short distance haulage 2
long distance haulage 2
3 Change wheel hub bearing grease, check taper roller
bearings and rotary shaft seal for wear.
ECO
Plus
hub system Offroad conditions
3)
3
Onroad conditions
3)
3
Offroad conditions 3
Onroad conditions 3
ECO hub system 33
Conventional hub bearing 3
every 3 years latest every 3 years or min. every 500,000 km
3) 2)
1)
1)
1)
For the positions 1 to 2 the use of a highpressure central lubrication system which is capable of feeding special longlife
grease of consistency class 23 is permissible. The use of liquid lubricants is not permitted!