Data Transfer: Select Dump and Clear if the user wishes to clear the data on recorder after dumping
data to PC or CF card. Select Transfer and remain if the user wishes to remain the data on recorder after
transferring data to PC or CF card.
Keypad Sound: Selects the following four options: disable, minimum, medium or maximum
LCD:
Screensaver: To prolong the life of the LCD display, it is suggested to set the display turn-off time in 1,
10, 20, 30, 40, 50 or 60 minutes after the user operates the recorder. It was initially set 10 minutes for
Screensaver from the factory. The recorder continues to recode data while it is in the screen saving
mode. The display turns on again by pressing any soft key or by Infrared sensor. When an alarm occurs,
it turns on the display as well.
Sensor:
Off & On: Keypad - Turn off & on by keypad. If the Screensaver is set 10 minutes, the display turns off
10 minutes after hands off from the recorder, and it turns on again after the user presses the keypad.
Off & On: IR – Turn off & on by infrared sensor. If it is the same Screensaver setting, the display turns
off 10 minutes after the user away from the recorder, and it turns on again when the user approaches the
recorder within 2 meters.
Off: IR, On: Keypad – Turn off by infrared sensor, and turn on by keypad. If it is the same Screensaver
setting, the display turns off 10 minutes after the user away from the recorder, and it turns on again after
the user presses the keypad.
Note:
◆ To use infrared IR sensor on recorder is a genius idea to prolong the lifetime of LCD display. It
senses the movement of body temperature when a user gets closer or walks away. (distance in about 2
meters).
Communication
PCTransfer: Selects RS-232/RS-485/RS-422, or standard Ethernet communication.
RS-232, RS-485, RS-422:
Address: 0 to 247 nodes for RS-485
Baud Rate: Selects it from various Baud rates 1200, 2400, 4800, 9600, 19200, 38400, 57600
or 115200.
Data Format: Selects it from three different data formats.
To Next Page
Loading...