Ethernet:
IP: Select Automation if the server on the network automatically allocates the IP address for the
recorder. Select User Define to manually set a fixed address for the recorder. Two new columns will
appear for keying in fixed addresses
IP Address: Defines the correct address of the recorder on the network
Subnet Mask: Defines the correct SubnetMask address on the network
Default Gateway: Different Gateway has different IP address on Ethernet.
Note:
▲ If Automation is selected, the IP address and SubnetMask are invisible. IP address can be found in 4.8
System Info mode under Configuration. Because the server could reallocate a new IP address after
power off and on, the user defining fixed addresses is recommended.
To Next Page
Loading...