BrakeForceOne H2O - Page 31

30 31
ENGLISH
) Take syringe tting out of bleeding port (lever).
) Put screw plug (4) into bleeding port and tighten with tightening torque
of 1 N·m (9 lbf·in) (pic. 25).
) Dry/clean lever if necessary.
) Fit lever again (– see tting of lever, page 12).
) Take syringe tting out of bleeding port (lever).
) Put screw plug (3) into bleeding port and tighten with tightening torque
1 N·m (9 lbf·in) (pic. 26).
) Dry/clean lever if necessary.
) Take out bleeding block and t (– see changing of pads, page 28).
) Fit capiler, if disassembled before (– see tting and adjusting the
caliper, page 23).
) Install wheel – be careful when placing rotors between pads.
) Adjust and close the quick release skewer.
) Pull lever rmly a couple of times then festhalten.
) Make sure that there is no uid leaking out of the system.
) Make sure that rotor is centered and runs freely between pads.
) (Re)adjust caliper if neccessary (– see tting and adjusting the caliper,
page 23).
) Make sure that rotors respond immediately and the pressure point is
clearly dened (repeat bleeding if necessary).
) Adjust pressure point if neccessary (– see adjusting pressure point,
page 26).
 Your BFO disk brake is now vented.
Picture 23 Picture 25Picture 24 Picture 26