Branson 2100 - Charging Circuit (Panel Board and Wiring Harness); Engine Oil Pressure Switch Panel Board and Wiring Harness

ELECTRIC SYSTEM
KUKJE MACHINERY CO., LTD.
178
(11) Instrument Pannel
Easy Checker
1. Remove the panel board and disconnect the
connector from it.
2. Turn the main switch on.
3. Measure the voltage with a voltmeter across the
terminal (Red/Yellow) and the earth terminal (Black).
4. If the voltage differs from the battery voltage, the
wiring harness fuses and main switch should be
checked.
Charging Circuit (Panel Board and Wiring Harness)
1. Remove the panel board from tractor.
2. Disconnect the 6P connector from the regulator after turning the main switch off.
3. Turn the main switch on and connect a jumper lead from the wiring harness connector terminal (Black) to
the chassis.
4. If the charge lamp does not light, the panel board circuit, regulator, wiring harness, or fuse is fault.
(1)Regulator (a) From charge Lamp
Engine Oil Pressure Switch Panel Board and Wiring Harness
1. Disconnect the lead from the engine oil pressure switch after
turning the main switch OFF.
2. Turn the main switch ON and connect a jumper lead from the lead
to the chassis.
3. If the engine oil pressure indicator lamp does not light, the panel
board circuit or the wiring harness is faulty.
(1) Engine Oil Pressure Switch (a) From Oil Pressure Lamp
8. CHECKING DISASSEMBLING AND SERVICING