43 Operating Your Ultrasonic Bath
Application Hints
First time cleaning - first experiment with one piece, then proceed with
the remainder.
Solution level - Be sure to maintain solution level within 1/2 inch (1.3 cm)
of the tank’s “operating level” line. Surface activity can vary with liquid
level.
Load size - It is faster and more efficient to run several small loads rather
than a few big loads.
Placing items - Never allow items to sit on the bottom of the tank. Always
place them in a tray or beaker or suspend in the solution.
Rinsing items - After cleaning, use a clean water bath to rinse away
chemicals adhering to items.
Lubricating items - When necessary, re-lubricate items immediately
after cleaning.
Drying items - Air drying at room temperature works for some items.
Place parts requiring faster drying time under hot air blowers or in ovens.
Please call your local distributor if you have application questions.
• Never clean novelty or inexpensive jewelry in the ultrasonic bath.
The combination of heat and vibration may loosen a cement-held
setting.
• Never clean gemstones such as emerald, amethyst, pearl, opal,
coral, turquoise, peridot or lapis lazuli in the ultrasonic bath.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
