Branson 3015r - Page 250

4
-
78
42hW-201601
CHAPTER 4 TRANSMISSION 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
When installing the screw (1) to the bear-
ing support, tighten it to the specied torque
and caulk the mounting plate (2) to the screw
groove to x the screw rmly.
Tightening torque................. 78.4 ~ 98 N.m
8 ~ 10 kgf.m
57.6 ~ 72 lb.ft
•

4. Unscrew the bolts (1) and removethe mounting
plate (2), bearing support (3)and spring holder
(4).Pulloutthesnapring(5)ontheoppositeside
and remove the shim (6), ball bearing (7) and
differentialsystemassembly(8).
K42W4B1A
K42W4B2A
K42W4C1A
3. RemovethePTOdrivegearshaft(1).
K42W4A9A