Branson 3015r - Replacing Transmission;Hydraulic Filter; Changing Transmission Fluid;Hydraulic Oil

42hW-201601
1
-
31
CHAPTER 1 GENERAL INFORMATION3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
1
8.2.12 CHANGING TRANSMISSION FLUID/

4. Remove the drain plug (1).
F42W123A
Start the engine and activate several hydraulic
functions to increase oil temperature.
Park the tractor on level ground and lower the
implement onto the ground.
Stop the engine, remove the ignition key and
apply the parking brake. (Set the transmission
into the neutral state.)
1.
2.
3.
F42W124A
Replace the transmission uid/hydraulicoil lter
element (2).
Before adding clean oil, replace the seal and
tighten the drain plug to 5 kg.m (36 lb.ft).
5.
6.
8.2.11 REPLACING TRANSMISSION/

Removethelterelement(1)byunscrewingit.
Apply clean oilontothesealringof anewlter
elementandtightenthislterelement.
Starttheengineandcheckthelterbaseforfuel
leakage.
Stop the engine and check the oil level. If the
level is too low, add more oil.
1.
2.
3.
4.
CAUTION

 -


 -

F42W122A