6.
Using a spanner wrench, tighten securely (use 220 in lbs/25 Nm
torque).
7.
Clean the mating surfaces of the booster and horn, and remove any
foreign matter from the hole and stud. Make sure that the stud is tight
in the horn. Use the specifications in Figure 3-10.
8.
Coat one of the mating surfaces with a thin film of silicone grease. Be
careful not to apply grease to the threaded stud.
9.
Screw the horn into the booster and, using a spanner wrench, tighten
securely (use 220 in lbs/25 Nm torque).
Caution:
If necessary,. secure the largest portion of a square or
rectangular horn in a soft-jawed vise. NEVER attempt
to assemble or remove a
.
horn by holding the converter
housing or the booster clamp ring in a vise.
Installation
3-12
900IW+
To Next Page
Loading...
