Braun E16x442 - Parameters of Monitor E1665; Summary of Parameters and Default Values

I E16x442 Rev: 00 Page 39 of 73
8. Parameters of Monitor E1665
8.1. Summary of parameters and their default values
Param.
No.
Default
Value
Parameter Function
P00.xx
Code figure, Parameter Lock
P00.00
0000
Code figure
.01
0000
New code figure
.02
0
Parameter Lock : 0: locked / 1: enabled
.03
0
Front side Reset: 0: not possible / 1: possible
P01.xx
Input, Scaling
P01.00
0
Reserved for future applications
.01
10000
Value of nominal input frequency in Hz
.02
0
Decimals of speed value for SP2, SP3 PROFIBUS-Output
.03
10000
Nominal speed in RPM
.04
00001
Lower limit of the speed range
.05
001
Predivider (range 001 - 255)
.06
0
Reserved for future applications
.07
0
Decimals for acceleration
.08
01000
Maximum acceleration in XXXX or XXX.X RPM/sec
.09
1
No. of acceleration measurements included in calculation of SP1var
P02.xx
Display, Starter, Tests
P02.00
0
Reserved for future applications
.01
0.3
Display updating sequence (in x.x sec)
.02
000
Time elapse of starter phase (in xxx sec)
.03
1
Reserved for future application
.04
4
Sensor monitoring: 0: off / 1: on / 2: on, latched / 4: on, no trip
.05
1
Mode of sensor monitoring: 0 ... 7 (see table)
.06
1
Lowspeed Monitoring "n < SP2": 0 ... 4 (see table)
.07
5
Speed comparison test : 0 ... 5 (see table)
.08
030
Permissible Speed Difference between Sensors (in xxx RPM)
.09
05
Number of errors before reporting
.10
1
Monitor Warning Alarm at Trip: 0 ... 4 (see table)
.11
1
Latch Monitor Warning Alarm: 0: no / 1: yes, all alarms / 2: yes, first one only
P03.xx
Overspeed Alarm SP1
P03.00
00010
Setpoint SP1A in RPM
.01
05.0
Hysteresis bandwidth (XX.X % of. SP1)
.02
0
Alarm to be latched / energized or de-energized to trip:
0: no, de-energize / 1: yes, de-energize / 2: no, energize / 3: yes, energize
.03
00001
Setpoint SP1B in RPM
.04
0
Setpoint SP1var : 0: not active / 1: active
Continued on next page