36
Chapter 3
SPECIAL FUNCTIONS
• Select the desired drug with t and press l.
The pump now offers the possible therapy profiles.
• Select “Intermittent Mode” with
t and press l. The therapy settings for
“Intermittent Mode” are shown on the display.
• For changing the parameters, press
l to change and k to confirm.
Note: Bolus rate is calculated by editable parameters. These parameters have to
be checked by the user before starting the infusion.
The pump can be started now by pressing
sf.
Starting Intermittent Mode via Special Function Menu:
• Switch on pump with
sf and wait until self-check is finished.
• Insert disposable.
• Go to Special Functions Menu and select Intermittent Mode.
• Press
l to enter parameters and k to confirm.
After entering all desired parameters the pump can be started by pressing
sf.
In the upper part of the display the icon for “Intermittent Mode” appears.
In bolus phase the screen shows the following:
After the bolus phase the pump switches to rate phase and the screen shows
the following:
Note: To cancel bolus infusion in the Intermittet Bolus therapy at any time it is
only possible with
sf.
Note: The delivery of drugs can be stopped and started again in the Intermittent
Mode at any time by pressing
sf. This will not have any effect on the settings
of the therapy.
During infusion it is possible to change the bolus volume, amount, VTBI as well as the
time interval.
• Press
C.
• Use
t to navigate through the parameter list and select the parameter to
be changed with
l.
The pump now delivers the
predefined bolus.
The pump now delivers the
predefined rate.
To Next Page
Loading...
