65
connector of a power supply or combi cable may be used to cover the
connections during cleaning operations. Ensure that any connectors used to
cover are not connected to a wall outlet or other electrical source. Once the
cleaning has been completed, remove the connector and inspect all connectors
for residual moisture and evidence of damage or breakdown to the plating on
the connectors. Allow any residual moisture to evaporate before plugging the
device into a wall outlet. Replace any connectors which exhibit damage or
evidence of plating breakdown prior to returning the device to
service. Utilize electrical contact cleaner that does not react with plastics to
remove any deposits of material which may be present inside the electrical
connectors as required.
W Caution: Do not allow liquids to enter into or come into contact with
any openings or electrical connections on the pump or power supply.
Fluid exposure in these areas may result in the risk of short circuit,
corrosion or breakdown of sensitive electrical components, and/or electrical
shock. If fluid exposure occurs, the device should be swapped out with
another device in a manner that presents minimal interruption to patient
care. The device should remain unplugged until it can be inspected by a
trained technician for any evidence of damage and/or residual moisture
which may impair the function of the device.
WCaution: Do not touch line guide element or peristalitic pumping area of
pump with sharp object.
When reinserting the line guide element, make sure that it is not damaged
and that it audibly locks in place.
Substances of the listed groups are approved for cleaning and regular
disinfection routines of surfaces according to recommendation of disinfectant
manufacturer.
Note: Do not use Hexaquart® or other alkylamine containing disinfectants.
Recommended: disinfectant for wiping available from B. Braun: Meliseptol®
Foam pure, Melsitt 10% and Melsept SF 10%.
Group
Quaternary ammonium
compounds
Active Substance
DDAC (Didecyldimethylammoniumchlorid)
Aldehydes
BAC (Benzalkoniumchlorid)
Peroxides
Active chlorine
Acid
Glutaral
Glyoxal
Hydrogen Peroxide
Sodium Hypochlorite
Citric Acid
WARRANTY / TRAINING / TSC* / SERVICE / DISINFECTING / DISPOSAL
Chapter 10
To Next Page
Loading...
