- 59 -
message caused by what to do?
There is a problem with the
auto-code detection.
Please insert a new test strip
and perform your test again.
If the problem persists,
please contact B. Braun
representative.
There is a problem with the
auto-code detection.
If the LCD screen shows “Sun”
message alternately with Er 6,
avoid the direct sunlight and
insert test strip again.
No results obtained on
the meter.
The meter memory is empty
until you perform a first blood
glucose measurement.
The ambient temperature
is too low.
Place the meter at the oper-
ating temperature range
10-40 °C (50 - 104 °F) for more
than 10 minutes and re-test.
To Next Page
Loading...
