REMOVING/REPLACING THE MAIN COMPONENTS PV 101+/PV 102+ Service Manual
3–4 BREAS MEDICAL Doc. No. 003259 En Issue: X-1
3.4 Removing and reassembling the main assembly
All the main internal components – blower unit, power board and MDA board – are
mounted on the base plate.
To remove the main assembly:
1 Remove the upper casing (See section 3.2).
2 Turn the PV 101+/PV 102+ upside down. Remove the M4 nut that fastens the
blower unit rubber mount.
3 Remove the five screws on the lower casing that hold the base plate.
5 × TX10
3
2
1 × M4
Compound
nut
To Next Page
Loading...
