Breckwell SP6000 - Control Panel Reset

Chapter2–Operation
Page14
CONTROL PANEL RESET

Itmaybecomenecessarytoresetthecontrolpaneltotheoriginalfactoryspecificationsandsettings.Thiscouldbeduetoerratic
operationfromthecontrolpanel,powerfluctuations,orotherreasons.Itiseasytoaccomplishandwilloftencorrectanyfrustrating
issuesthatyoumaybehaving.

In
ordertoresetthecontrolpanel,simplychangethefueltype.

Forinstance,ifyouhavebeenburningthestoveonthePELLETSsettings,presstheFUELTYPEbuttontochangethefueltypeto
CORN.PressitagaintochangebacktoPELLETSandyouhaveresetthecontrol
paneltotheoriginalfactorysettings.

ThesameistrueifyougofromCORNtoPELLETSandbackagaintoCORN.

NOTE:T
HEUNITMUSTBEINTHESTART‐UPCYCLEINORDERTOCHANGETHEFUELTYPE.YOUCANNOTCHANGETHEFUELTYPEWHILETHEUNITISRUNNINGIN
NORMALOPERATION
.
CONTROL PANEL RESET



WHEN IN DOUBT, RESET THE BOARD