Bresser 4Cast - Back Light; Unit Setting

61
When clock reach the alarm time, alarm sound will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in the next
day.
- By pressing [ALARM / SNOOZE] key to enter snooze that the alarm will sound again after 5 minutes.
- By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will activate again in
the next day
- By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day.
NOTE:
- The snooze could be used continuously in 24 hours.
- During the snooze, the alarm icon “
” will keep ashing.
4.4.3 UNIT SETTING
Use the [ UNIT ] key to change the unit of measure of the reading on the console display.
Below is the operation step:
- Press and hold [ UNIT ] key for 2 seconds to enter the unit setting mode.
- Short press [ UNIT] key to proceed to the next setting step.
- Press [
/ INDEX ] or [ / MODE ] key to change the value. Press and hold the key for
quick-adjust.
- Press and hold [ UNIT ] key for 2 seconds to exit the unit setting mode at any time.
Setting items table:
Step Mode Setting procedure
1
Temperature unit
Press [
/ INDEX ] or [ / MODE ] key to select °C or °F
2
Rain unit
Press [
/ INDEX ] or [ / MODE ] key to select mm or in
3
Wind speed unit
Press [
/ INDEX ] or [ / MODE ] key to select m/s, km/h, knots or mph
4
Baro pressure unit
Press [
/ INDEX ] or [ / MODE ] key to select hPa, inHg or mmHg
5
Light intensity
Press [
/ INDEX ] or [ / MODE ] key to select Klux, Kfc or W/m
2
4.4.4 BACK LIGHT
The main unit back light can be adjust, using the [ HI / LO / AUTO ] sliding switch to select the appropriate
brightness:
- Slide to the [ HI ] position for the brighter back light.
- Slide to the [ LO ] position for the dimmer back light.
- Slide to the [ AUTO ] position for the auto adjust back light that according to environment light level.
EN