www.bresser.de
General Information
Important notes:
- - Please read this manual carefully before using the machine.
- - This manual assumes that you are using the Windows 7 operating system to
operate the 3D Printer.
- - The current version of the REXprint software is used.
This manual contains all necessary information for setting up and operating the
device.
The operating instructions consist of the following parts: Introduction, general and
safety information, operation and product service.
For service requests, please have ready:
Item nr: 2010600
Product reference BRESSER T-REX 2 WLAN 3D Printer
Instruction manual:
Manual_2010600_Wifi-3D-Printer-T-REX-2_de_BRESSER_v032021a.docx
To Next Page
Loading...
