www.bresser.de
Safety Precautions
① Do not leave the device unattended for a longtime.
② Do not make any changes to the device.
③ Lower the pressure plate before inserting/removing filament. (The distance
between nozzle and pressure plate should be at least 50 mm)
④ Operate the device in a well-ventilated environment.
⑤ Do not use the device for unlawful purposes.
⑥ Do not use the appliance to make containers for storing food.
⑦ Do not use the device to manufacture electrical equipment.
⑧ Do not put models in your mouth.
⑨ Do not remove the models by applying force.
Environmental conditions
TEMPERATURE: Room temperature 15 to 30 °C ℃
Moisture: 20% ~ 70%
Filament specifications
Use the filament only for the intended purpose! Use only the BRESSER filament or a
filament of the brands authorised by BRESSER!
Filament storage
A certain degree of decay can be observed in all polymers over time. Only unpack
the filament when you need it. The filament should be stored in a clean and dry
environment and protected from sunlight.
Legal notice
All information in this document can be extended or adapted without prior notice.
BRESSER GMBH MAKES NO WARRANTIES WITH RESPECT TO THIS
DOCUMENT, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Furthermore, BRESSER GmbH does not assume any liability for errors contained in
this manual or for incidental consequential damages in connection with the delivery,
performance or use of this material.
To Next Page
Loading...
