EasyManuals Logo

BrightDrop EV600 2022 User Manual

BrightDrop EV600 2022
229 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
BrightDrop EV600 Owner Manual (GMNA-Localizing-U.S.-15563034) -
2022 - CRC - 9/29/21
Keys, Doors, and Windows 9
Keyless Unlocking/Locking from the
Passenger Doors
When the doors are locked and the remote
key is within 1 m (3 ft) of the door handle,
pressing the lock/unlock button on a
passenger door touchpad will unlock all
doors. Pressing the lock/unlock button will
cause all doors to lock if any of the
following occur:
.
The lock/unlock button was used to
unlock all doors.
.
Any vehicle door has been opened and all
doors are now closed.
Disable/Enable Keyless Unlocking of Exterior
Door Handles and Rear Sliding Door
If equipped, keyless unlocking of the exterior
door handles and rear sliding door can be
disabled and enabled.
Disabling Keyless Unlocking:
With the vehicle off, press and hold
Q and
K on the remote key at the same time for
approximately three seconds. The turn signal
lamps will flash four times quickly to
indicate access is disabled. Using any
exterior handle to unlock the doors or open
the rear sliding door will cause the turn
signal lamps to flash four times quickly,
indicating access is disabled. If disabled,
disarm the alarm system before starting the
vehicle.
Disabling Keyless Unlocking may also be
configured under Vehicle Personalization
0 71.
Enabling Keyless Unlocking:
With the vehicle off, press and hold
Q and
K on the remote key at the same time for
approximately three seconds. The turn signal
lamps will flash twice quickly to indicate
access is enabled.
Enabling Keyless Unlocking may also be
configured under Vehicle Personalization
0 71.
Passive Locking
The Keyless Access system will lock the
vehicle several seconds after all doors are
closed, if the vehicle is off and at least one
remote key has been removed from the
interior, or none remain in the interior.
If other electronic devices interfere with the
remote key signal, the vehicle may not
detect the remote key inside the vehicle.
If passive locking is enabled, the doors may
lock with the remote key inside the vehicle.
Do not leave the remote key in an
unattended vehicle.
To customize the doors to automatically lock
when exiting the vehicle, see Remote Lock,
Unlock, Start under Vehicle Personalization
0 71.
Temporary Disable of Passive Locking
Temporarily disable passive locking by
pressing and holding
K on the interior door
switch with a door open for at least
four seconds, or until three chimes are
heard. Passive locking will then remain
disabled until
Q on the interior door is
pressed, or until the vehicle is turned on.
Remote Left In Vehicle Alert
When the vehicle is turned off and a remote
key is left in the vehicle, the horn will chirp
three times after all doors are closed. To
turn on or off see Vehicle Personalization
0 71.
Remote Removed From Vehicle Alert
If the vehicle is on with a door open, and
then all doors are closed, the vehicle will
check for remote keys inside. If a remote
key is not detected, the Driver Information
Center (DIC) will display NO KEY FOUND and

Table of Contents

Other manuals for BrightDrop EV600 2022

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BrightDrop EV600 2022 and is the answer not in the manual?

BrightDrop EV600 2022 Specifications

General IconGeneral
BrandBrightDrop
ModelEV600 2022
CategoryAutomobile
LanguageEnglish

Related product manuals