4
Revision 1.1
09/2024
B1051UL
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS
IMPORTANT SAFETY INSTRUCTIONS
Please read the following precautions carefully before using this equipment.
This unit contains high voltage components which, may expose you to the risk of electric shock.
WARNING - To reduce the risk of re, electric shock, or injury to persons when using your appliance, follow basic
precautions, including the following;
Do not open the enclosure without isolating the signal and supply sources. Ensure that these sources have
been isolated for at least 5 minutes before entering the enclosure.
Means for disconnection must be incorporated in accordance with the wiring rules.
Do not mount the unit to unstable, irregular or non-vertical surfaces.
Do not place heavy objects on top of the unit.
Do not attempt to place items (such as screwdrivers) into the moving parts of the pump head. The Pumps have
moving parts which are a risk of injury if they get in contact with the operator’s hands or clothing. Isolate the power
supply before attempting to change the pump tube or remove any pump parts.
Do not power the unit outside of the values stated on the rating label.
Do not install or store this appliance where it will be exposed to the weather.
Do not use damaged or frayed cables.
Do not dismantle or modify this equipment.
Do not tamper with controls.
Do not repair or replace any part of the appliance or attempt any servicing unless specically recommended in the
user-maintenance instructions or in published user-repair instructions that you understand and have the skills to
carry out.
Do not allow the appliance to be used by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
Do not allow children to play with the appliance.
Do not use appliance if the supply cord is damaged. This must be replaced by the manufacturer, its service agent
or similarly qualied persons in order to avoid a hazard.
Always ensure that care is taken when handling chemicals.
Cycle time settings shall be changed only by a responsible person, authorized by the manufacturer. The password
code to enter programming mode shall be kept condential and shall not be distributed.
If factory settings need to be changed: NEVER exceed 3 min. ON and NEVER set less than 9 min. OFF time for
each pump.
The Pumps have moving parts which are a risk of injury if they get in contact with the operator’s hands or clothing.
Isolate the power supply before attempting to change the pump tube or remove any pump parts.
PLEASE SAVE THESE INSTRUCTIONS
To Next Page
Loading...
