3
SAFETY INFORMATION
WARNING: To reduce risk of injury and property damage, you must read this entire guide before
assembling, installing and operating the dispenser.
WARNING: This product dispenses water at very high temperatures. Failure to use properly can
cause personal injury. When operating this dispenser, always exercise basic safety
precautions, including the following:
• Prior to use, this dispenser must be properly assembled and installed in
accordance with this manual.
• For indoor use only. Keep the water dispenser in a dry place away from direct
sunlight. Do NOT use outdoors.
• Install and use only on a hard, at and level surface.
• Do NOT place the water dispenser in an enclosed space or cabinet.
• Do NOT operate the dispenser in the presence of explosive fumes.
• Use only properly grounded outlets.
• Do not use an extension cord.
• Always grasp the plug and pull straight out from the outlet. Never unplug by pulling
on the power cord.
• Do NOT use the dispenser if the cord becomes frayed or otherwise damaged. If
the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a hazard.
• To protect against electric shock, do NOT immerse cord, plug, or any other part of
the dispenser in water or other liquids.
• Ensure the water dispenser is unplugged prior to cleaning.
• Never allow children to dispense hot water without proper and direct supervision.
Unplug the unit to prevent unsupervised use by children.
• Service should be performed only by a certied technician.
• The appliance must not be cleaned by a water jet and is not suitable for
installation in an area where a water jet could be used.
WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear
of obstruction.
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
• This appliance should work under environment of temperatures from 4°C~40°C
(39°F~104°F) and humidity ≤90%.
• Never turn the machine upside down or lean it more than 45°.
• After turning the dispenser off, allow the dispenser to sit idle for 3 minutes before
turning on again.
To Next Page
Loading...
Need help?
General
