9
OPERATION
IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During
transit, dust and odors can accumulate in the tank and lines. Dispense and
dispose at least one quart of water prior to drinking any water.
Turn the Dispenser On/Off
IMPORTANT: Before you activate the hot and cold switches, ensure water has lled the tanks
inside the dispenser in order to prevent dry heating.
1. Plug in the dispenser and turn the On/Off switch to On.
2. Run water through the cold and hot water taps until water begins to dispense.
3. To power on the cooling system, ip the cooling switch to the On position.
4. To power on the heating system, ip the heating switch to the On position.
Dispense Cold Water
NOTE: Water will take approximately 1 hour after plugging in and turning on to become
completely chilled. The cooling light will turn off once the water has been fully chilled.
1. Press the cold water button on the dispenser control panel and then press your drinking glass
or container against the water outlet to dispense cold water.
2. Release when your container is full.
Dispense Hot Water and Activate Child Safety Lock
CAUTION: This unit dispenses water at temperatures that can cause severe burns. Avoid direct
contact with hot water. Keep children and pets away from the unit while dispensing.
Never allow children to dispense hot water without proper and direct supervision.
Disable the heating feature by switching the heating convenience switch to the Off
position.
NOTE: Water will take approximately 15-20 minutes after plugging in and turning on to reach
its hottest temperature. The heating light will turn off once the water has been fully
heated.
1. This water dispenser is equipped with a child safety feature in order to prevent inadvertent
dispensing. To enable dispensing of hot water, press the hot water button on the dispenser
control panel and then press your drinking glass or container against the water outlet to
dispense hot water.
2. To disable hot water, press the child lock button on the dispenser control panel.
3. Release when your container is full.
To Next Page
Loading...
Need help?
General
