8
4. Install the Filters and Complete the Installation
A. After ushing, twist each lter (D and E) clockwise into the lter housings located inside the
dispenser cabinet. The sediment lter (D) goes on the left, the carbon +ultra ltration lter (E)
on the right.
D
E
B. Remove the safety plug from the water inlet hole on the back of the dispenser by pushing in the
inlet hole collar and then gently pulling out the plug.
C. Connect the tip of the shut-off valve tube (B) into the water inlet hole on the back of the
dispenser. Then turn on the main water supply and ensure the valve in the tube (B) is on.
B
To Next Page
Loading...
