7
E. Gently tug on the tube (B) to ensure a
secure connection with the feed water
adapter (E).
E
B
3. Flush the Filters
IMPORTANT: Follow this procedure every time you replace your lters.
IMPORTANT: Ensure the water supply is off before you begin.
A. Connect a lter (D) to the lter housing (C)
by twisting the lter (D) clockwise.
C
D
B. Connect the tip of the shut-off valve tube (B)
to the left side of the lter housing (C).
C. Connect the lter ushing tube (A) to the
right side of the lter housing (C) and lay the
open end of the lter ushing tube (A) over
a sink or receptacle to collect water.
A
C
B
D. Flush each lter for a minimum of
5minutes. The recommended rate is
1.5‑3gallons of water (about 10 minutes)
oruntil the water is clear in appearance.
E. Shut off the valve at the water source and
remove the lter housing from the tube (B).
B
To Next Page
Loading...
Need help?
General
