10
10
Operation
IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and
odors can accumulate in the tank and lines. Dispense and dispose of at least one quart of water
prior to drinking any water.
Turn the Dispenser On/O
IMPORTANT: Before you activate the hot and cold switches, ensure water has filled the tanks inside the
dispenser in order to prevent dry heating.
1. Plug in the dispenser.
2. Press the hot and cold water buttons until water begins to dispense.
3. To power on the cooling system, flip the cold water switch to the On position.
4. To power on the heating system, flip the hot water switch to the On position.
Set the Clock
1. Press and hold the up and down arrow buttons for 3 seconds until the clock display begins to blink.
2. Press the cold water button to set the minute and the hot water button to set the hour. Use the up and down
arrow buttons to scroll until the correct minute/hour is displayed.
3. Press the lock button when finished.
Set the Cold Temperature Setting
1. Press the lock button and the cold water button at the same time for 3 seconds until the cold water button starts
to blink and the current cold water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired cold water temperature. The range is 39˚ F to 59˚ F
(4˚ C to 15˚ C).
3. Press the lock button when finished. The temperature stops blinking and the time is displayed.
Set the Hot Temperature Setting
1. Press the lock button and the hot water button at the same time for 3 seconds until the hot water button starts to
blink and the current hot water temperature appears on the display.
2. Use the up and down arrow buttons to scroll to your desired hot water temperature. The range is 174 °F to 194 °F
(79 °C to 90 °C).
3. Press the lock button when finished. The temperature stops blinking and the time is displayed.
Dispense Cold Water
NOTE: Water will take approximately 1 hour after plugging in and turning on to become completely chilled.
1. Place a drinking glass or container under the tap and press the cold water button to dispense cold water.
2. Release the button when your container is full.
To Next Page
Loading...
Need help?
General
