BRIO CLPOU720UVRO4X - Filter Flushing and Final Installation; Flush the Filters

8
8
4. Flush the Filters
IMPORTANT: Follow this procedure every time you replace your filters.
IMPORTANT: Ensure the water supply is o before you begin.
A. Connect a filter (D) to the filter housing (C) by
twisting the filter (D) clockwise.
C
D
B. Connect the tip of the shut-o valve tube (B)
to the left side of the filter housing (C).
C. Connect the filter flushing tube (A) to the
right side of the filter housing (C) and lay the
open end of the filter flushing tube (A) over a
sink or receptacle to collect water.
A
C
B
D. Turn on valve at water source. Flush each
filter for a minimum of 5minutes. The
recommended rate is 1.5-3gallons of water
(about 10 minutes) oruntil the water is clear
in appearance.
E. Shut o the valve at the water source and
remove the filter housing from the tube (B).
B