EasyManuals Logo

BRIO CLPOURO420SCV2 User Manual

BRIO CLPOURO420SCV2
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
Cleaning and Maintenance
Use the Self-Cleaning Ozone Feature
It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks and water lines.
To activate the self-cleaning cycle, press in the
self-cleaning switch (15), hold for 5 seconds, and release.
The power indicator light on the front of the
dispenser will begin blinking, indicating the
cleaning process is underway.
During the cleaning cycle, ozone is produced and injected into the water system. This ozone kills bacteria and biofilms
typically found in water dispensers. By the time the cleaning cycle ends, the ozone is converted to harmless oxygen
and emitted into the air.
IMPORTANT: The cycle takes 90 minutes to complete. During this time do not dispense and drink the water.
Doing so may result in an odd taste. For your convenience, we recommend that you do this during
a period when the dispenser is not in use, such as overnight hours or when sta is away from the
oce. During the cycle you may smell a faint trace of ozone.
Care and Maintenance
Keep this dispenser in a dry and cool place and avoid direct sunshine.
Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall.
Never put the dispenser on paper or foam, which may store water and then cause creepage. Never put anything
flammable beside this machine.
Do not use the dispenser outdoors or in a place that can be splashed by water.
If the dispenser is not in use for longer than a 24-hour period, turn o the heating switch or the refrigerating
switch to save power and drain any remaining water.
Clean your cabinet, controls, bottle probe and spout each time you change your water bottle. Use a clean soft
cloth and a food grade sanitizer or bleach.
Empty and clean the drip tray, grid and float as needed.
Periodically check the filter reset switch (19) on the back of the dispenser to ensure your filter is changed every 6
to 12 months, depending on how heavily the unit is used. This switch will flash red when it is time to change your
filter.
15
1 2 3
Self Clean

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BRIO CLPOURO420SCV2 and is the answer not in the manual?

BRIO CLPOURO420SCV2 Specifications

General IconGeneral
BrandBRIO
ModelCLPOURO420SCV2
CategoryWater Dispenser
LanguageEnglish

Related product manuals