Briot ALTA EVOLUTION Blocker - Page 8

ALTA EVOLUTION / EVOLUTION GT … User manual
1
ALTA EVOLUTION / EVOLUTION GT
1-3
1.2. SETTING UP
1.2.1. WORKBENCH PREPARATION
Before installing the machine, check that the workbench corresponds to the following characteristics:
Install the machine on a stable, level workbench.
Provide a mark measuring of 360 mm x 600 mm on the workbench
Do not place any obstacles (cabinet, shelf, etc.) lower than 600 mm above the workbench.
Allow sufficient distance between the ATTITUDE blocker and the edger.
Note: the standard connection lead is 5m long.
Prepare a grounded 16 A power socket, protected by a 30 mA differential circuit breaker.
Prepare a RJ45 Ethernet connector and a network access to facilitate the updating of your machine.
Install the machine away from any source of heat, dust contamination or humidity contamination (a non-
enclosed water tank, for example).
Install the machine away from any source of strong light.
1.2.2. INSTALLATION
To avoid damaging the
machine's internal
components, do not turn on
the machine
1