ALTA EVOLUTION / EVOLUTION GT … User manual
ALTA EVOLUTION / EVOLUTION GT
6.2. CENTERING DEVICE/BLOCKER MAINTENANCE
CLEAN THE BEARING SURFACE
6.2.1.
To clean the bearing surface, follow the steps below:
1- Remove any component that may hinder proper performance of the operation.
2- Clean with a soft, dry, grease-free and lint-free cloth.
Note: It is recommended to clean the installation surface with a circular movement from the centre outwards.
CAUTION! AVOID CONTAMINATING THE INSTALLATION SURFACE WITH GREASY SUBSTANCES OR YOUR FINGERS.
THE GUARANTEE WILL NOT COVER ANY DEVICE MALFUNCTIONS CAUSED BY LOSS OF THE BEARING SURFACE'S
OPACITY.
6.3. TOUCH SCREEN MAINTENANCE
CLEANING THE TOUCH SCREEN 6.3.1.
To clean the touch screen, first switch off the machine, if was turned on.
Clean the screen gently with a soft, dry lint-free cloth.
CAUTION! DO NOT USE PRODUCTS SUCH AS WATER OR CHEMICAL AGENTS.
ETHYL ALCOHOL CAN BE USED WHEN A DRY CLOTH IS NOT EFFICIENT ENOUGH TO REMOVE STUBBORN STAINS.
THE GUARANTEE WILL NOT COVER ANY DAMAGE CAUSED BY IMPROPER MAINTENANCE OF THE TOUCH SCREEN.
To Next Page
Loading...