17
EMBLEM/ALLEGIANCE Canadian User Guide
8. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-o.
9. Attach the tether to a
designated anchor (see
vehicle owner’s manual)
and remove all slack (see
page 29).
Wrap excess
webbing in the elastic
strap and store in tether
storage pouch
.
10. Replace the seat cover.
Forward-Facing Installation with Lap-Shoulder Belt
9 All connections are secure and straps are not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be
parallel to vehicle seat.
9 No more than
7.5 cm (3 in.)
of the base hangs over the
edge of the vehicle seat.
9 The child seat cannot be moved front to back or side to
side more than 2.5 cm (1 in.) at the belt path. If the child
seat is not secure, repeat installation or use a dierent
seating location.
9 Any excess tether webbing is contained within your
vehicle and secured in the elastic strap.
9 The anti-rebound bar is removed.
To Next Page
Loading...
