Britax EMBLEM - Forward-Facing Lap Belt Installation

18
BRITAX Child Safety, Inc.
Lap Belt Installation
1. Remove the tether from the
pouch and place it up and
over the child seat back.
2. Adjust this child seat to
position 1 or 2 and place
forward-facing on the
vehicle seat (see page 24).
NOTE: Ensure that no
more than 7.5 cm (3 in.) of
the base hangs over the
edge of the vehicle seat.
IMPORTANT: Your child
seat may not perform as
intended if the base of the
child seat is not flat on the
vehicle seat.
3. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow and
unbuckle the harness .
4. Pull the head restraint/
head pad cover up,
then pull the seat cover
forward to access the
forward-facing belt path.
5. Route the vehicle seat
belt through the forward-
facing belt slots, ensuring
the vehicle belt is not
twisted, then buckle.
IMPORTANT: Do not
use lock-os for lap belt
installations.
6. Push down on the middle
of the child seat while
pulling the vehicle belt to
remove all slack.
NOTE: Ensure that the
vehicle belt is locked as
directed by your vehicle
owner’s manual.
7.5 cm