Britax EMBLEM - Forward-Facing Installation; Forward-Facing LUAS Installation

14
BRITAX Child Safety, Inc.
LUAS Installation
IMPORTANT: Do not install forward-facing with LUAS for
a child weighing more than 22.7 kg (50 lbs).
Forward-Facing Installation
1. Remove the lower
connectors from the
storage slots in the
base. Press the adjuster
release button and pull
the lower connector
strap to full length.
Repeat for the second
strap.
2. Remove the tether from
the pouch and place it
up and over the child
seat back.
3. Adjust this child seat to
position 1 or 2 and place
forward-facing on the
vehicle seat (see page
24).
NOTE: Ensure that no
more than 7.5 cm (3 in.) of
the base hangs over the
edge of the vehicle seat.
IMPORTANT: Your child
seat may not perform as
intended if the base of the
child seat is not flat on
the vehicle seat.
4. Firmly press the lower
connectors onto the
adjacent lower anchors.
a. A click helps confirm
attachment.
b. Verify that the lower
connector strap is
not twisted.
5. Push the child seat down
while pulling each lower
connector strap to tighten.
7.5 cm
IMPORTANT: Do NOT use the infant positioning pillow in
a forward-facing position.
IMPORTANT: Do NOT use the anti-rebound bar in a
forward-facing position.