Britax Poplar - ReboundReduce Stability Bar; Installing the ReboundReduce Stability Bar; Removing the ReboundReduce Stability Bar

20
ReboundReduce
TM
Stability Bar
IMPORTANT: The stability bar MUST be used for rear-
facing and must be removed for forward-facing
installation.
Do not use the stability bar to carry this child restraint.
WARNING!
Installing the ReboundReduce
TM
Stability Bar
1. Open the ClickTight.
a. Lift the front cover
ap.
b. Squeeze the
ClickTight release
buttons.
2. Insert the stability bar
into the two openings
at the front of the seat.
3. Ensure the
stability bar
release buttons are
completely engaged.
4. Pull the stability bar
away from child
restraint on both sides
to conrm connections.
Removing the ReboundReduce
TM
Stability Bar
1. Open the ClickTight.
a. Lift the front cover
ap.
b. Squeeze the
ClickTight release
buttons.
2. Push the stability bar
release button and pull
the stability bar away
on one side. Repeat on
the other side.
3. Close the ClickTight.
2
2
3
1
a
b
4