Britax Poplar - Forward-Facing Installation; Forward-Facing Child Fit and Safety

28
Forward-Facing Installation
IMPORTANT: Do not use the stability bar in a forward-
facing position.
Child Fit
Use forward facing:
• with children who weigh 10 –
29.5 kg (22 – 65 lbs); and
• who are 124.5 cm (49 in) or
less in height; and
• are able to walk unassisted;
and
• with harness straps in the
closest position above the
child’s shoulders, parallel to
level ground; and
• when the top of the ears are
below the top of the head
restraint.
Britax strongly recommends children should be
secured with a harness system to the highest weight or
height specied.
IMPORTANT: The tether MUST be used when installing
the child seat forward-facing.
Lap-Shoulder Belt Installation
(Preferred Method)
1. Remove the tether.
a. Extend the tether
by lifting on the
tether adjuster.
b. Unhook the tether
hook from the back
of the child restraint
and place it over
the seat back.
1b
Shoulder
Level
Ear Level
NOTE: The ClickTight replaces the need for a
locked/switched vehicle belt retractor. Locking/
switching the lap-shoulder belt retractor can
be done after you follow the install instructions
included herein if desired. If the lap-shoulder belt
retractor has been locked, please refer to the
britax.ca/faqs to uninstall the child restraint
IMPORTANT: The harness pads must be stored for
children under 11.3 kg (25 lbs) forward-facing.