Britax Poplar - Rear-Facing Installation; Rear-Facing Child Fit and Safety

21
Rear-Facing Installation
Lap-Shoulder Belt Installation
(Preferred Method)
Child Fit
1. Attach the
ReboundReduce
TM
stability bar.
Use rear facing:
• with children who weigh
2.3 – 18.1 kg (5 – 40 lbs); and
• with harness straps in the
closest position below the
child’s shoulders; and
• when the top of the child’s
head is at least 2.5 cm (1 in)
below the top of the head
restraint.
Britax strongly recommends that children ride rear-
facing to the highest weight or height specied.
Britax recommends a child with no head and neck
control be in the most reclined position.
1
2.5 cm
1”
Shoulder
Level
IMPORTANT: The provided lower infant insert must be
used for children weighing 10 kg (22 lbs) or less in a
rear-facing position. Do not use over 10 kg (22 lbs) or in
a forward-facing position.
NOTE: The ClickTight replaces the need for a
locked/switched vehicle belt retractor. Locking/
switching the lap-shoulder belt retractor can
be done after you follow the install instructions
included herein if desired. If the lap-shoulder belt
retractor has been locked, please refer to the
britax.ca/faqs to uninstall the car seat.
IMPORTANT: Harness pads MUST be used with children
weighing above 10 kg (22 lbs) rear facing.