Brivo ACS Installation Manual ACS5000-E
ENG-WI-001 © 2005 Brivo Systems, LLC. All rights reserved. Page 18
d) Check each INPUT OUTPUT BOARD to confirm the LOCAL HRTBT has come
on and is blinking.
e) If any of these power indicators is not correct (i.e., the LED light does not come
on or does not begin blinking, check the connections from the power supply to
each of the circuit boards. If all connections are good but there is a still a problem
with the power indicator, contact Technical Support.
NOTE: A steady light is an indication of a problem, just as much as no light is.
3. If ALL power indicators are correct, attach the back-up battery and check that ALL
indicators remain the same. Only then should you go on to Installation Procedures.
To Next Page
Loading...