1-5
Weight For Basic Machine:
Total 44,800 pounds (20,320 kg)
Front Axle 23,730 pounds (10,310 kg)
Rear Axle 22,070 pounds (10010 kg)
Drawbar Pull: 30,000 pounds (13,600 kg)
Hoist Pull (Bare Drum) 13,100 pounds (5940 kg)
Boom Functions Boom Movement Boom Speeds
Rotation Continuous 3.5 rpm
Elevation 0-70 degrees 22 Seconds
Extension 40 feet (12.19 m) 25 Seconds
Hoist Line Speed 240 ft/min (73 m/min)
Maximum Boom Height:
Without Boom Extension 70 feet 0 inches (21.34 m)
With Boom Extension 87 feet 11 inches (26.80 m)
Horizontal Reach:
Without Boom Extension 60 feet 0 inches (18.29 m)
With Boom Extension 80 feet 0 inches (24.38 m)
Engine:
Cummins - QSB4.5L Turbo, EPA Tier 4i:
Cummins QSB4.5L Tier 4 Interim turbocharged diesel engine. Water and
charge air cooled, 4-cylinder, 272 CID (4.5L). It has a bore of 4.21 inches
(107mm), a stroke of 4.88 inches (124mm) and is rated at 163 hp (125kW) at
2500 rpm with 468 foot pounds (635 Nm) maximum torque at 1500 rpm.
100 amp alternator included. 50 gallon (190 L) fuel tank capacity. High
temperature and low oil pressure shutdown included in engine management
system. Throttle control switch for setting engine speed at 1200 or 1800 rpm.
Diesel oxidation catalyst muffler; air intake pre-cleaner; charge air cooler; 1500
watt, 120 VAC block heater and grid heater included. Tier 4 Interim engines
must use Ultra Low Sulfur Diesel (ULSD) fuel that meets the EPA defined sulfur
content of 15 parts per million (ppm).
Cummins - QSB4.5 Turbo EPA Tier 3:
Cummins Model QSB4.5 diesel engine, turbocharged, charge air cooled, four
cylinder, 4.5 liter (275 CID). U.S. EPA Tier 3 certified. Bore 4.21 inches (107
mm), stroke 4.88 inches (124 mm). Rated 160 hp (119 kw) at 2,500 rpm. 460
foot pounds (624 Nm) maximum torque at 1,500 rpm. 95 amp alternator. Oil
capacity, 11.6 quarts (11 L). Coolant capacity, 14 quarts (13.2 L). Electronic
controls for three engine speeds during crane operation – 640, 1200 or 1840
rpm. Protection system shuts down engine when coolant is too hot or oil
pressure is too low. Charge air cooler, grid heater and engine block heater
which plugs into 120 volt AC extension cord are included. Tier 3 engines require
the use of Low Sulfur Diesel (LSD) that meets the EPA defined sulfur content of
500 parts per million (ppm). Tier 3 engines may also use Ultra Low Sulfur Diesel
(ULSD) fuel that meets the EPA defined sulfur content of 15 ppm.
Net Weight: -110 lbs. (-50kg)
Fuel Tank: 50 gallon (190 L) capacity.
Courtesy of Crane.Market
To Next Page
Loading...
